Ready Remote 24921 Installationsanleitung PDF herunterladen (Seite 10)

Control Button (valet switch), 2-pin connector

BLACK INPUT

GREY OUTPUT

Installation Points

Note: The LED referenced within the installation section is the LED (pro-

gramming indicator) on the Control Module unless otherwise stated.

Virtual Tach

Note: Use of Virtual Tach does not require the Tach wire to be con-

nected.

To program Virtual Tach:

1. After the install is complete, remote start the engine. The program-

ming operation may require 3 cranks of the starter before the en-

gine starts and runs. Do not turn off the remote start if this happens,

it is a normal programming operation.

2. Once the engine begins running, let it run for at least 30 seconds.

3. Using the Remote, send the Remote start command to turn remote

start off. Virtual Tach is programmed.

Note: Virtual Tach is not recommended for diesel trucks.

Virtual Tach handles disengaging the starter motor during remote start-

ing – it does not address over-rev. For over-rev protection capability, the

tach wire must be connected.

Important: After successfully learning Virtual Tach, a small minority of

vehicle starters may over crank or under crank during remote start.

Virtual Tach ﬁne tune can be adjusted, see Feature Menu and Program-

ming System Features.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Keine Kommentare

Ready Remote 24921 Installationsanleitung Seite 10